www.PyleUSA.com
3
4. Down Button
A: Short press to turn on/o audio recording.
B: To select the marker in setting menu
5. Menu Button
Short press to pull out the setting menu.
Installation Guide
1. Before power on, insert micro SD card into device. Please
use high speed micro SD card (Class 10 or above), capacity
no less than 8GB，Maximum support card up to 32GB.
2. Install the suction cup mount and mount it near the
rearview mirror (recommended)
3. Plug the original car charger into the car cigarette lighter.
4. Connect the car charger to the camera and route the
cable. (along the edge of the windshield.)
5. Installed the rear camera near the license plate, (be careful
with the UP/DOWN direction of the camera) Cable can be
laid along the vehicle roof, after the installation, connect
the rear camera with the main device.
6. Start the engine, the camera should power on
automatically, and check the installation angle and other
functions.
Attention:
1. Please check the rear camera image to ensure proper
direction.
2. The installation requires some professional skill, if you are
not familiar with such work, you can go to the auto shop.
Function Introduction
1. Auto recording feature
With the car engine starts up, the camera will automatically
power on and start recording, charging indicator lights and
video indicator lights blinking. After the engine turns o,
the camera will automatically saves record les and shut
To Next Page
Loading...
Need help?
General
