Mounting...
When making electrical connections with your amplifier and vehicle battery, please take
precaution and have a professional, or install under the supervision of a professional.
Use the proper gauge wire for power and ground connections.
Wire the amplifier directly to the car battery.
For ground connection, use the shortest possible wire to a secure chassis ground.
Wire the remote connection to the auto start lead of your head unit, equalizer, or power
antenna.
Circuitry Protection
Built-in fuse systems and circuitry protection protect both the amplifiers and your
vehicle's electrical systems. If you ever need to replace the fuse, or feel your
system has become faulty, please contact Pyle technical support, or consult the
assistance of a trained professional. When replacing fuses, be sure to use ONLY a
fuse of the exact same type and rating, otherwise may result in damage or fire.
senses an input overload. a speaker short circuit, or extreme temperature
conditions. When the protection circuit is activated by any of these conditions, the
Protection LED will be illuminated. If this occurs, carefully inspect the system to
determine the source of the problem.
• If the shutdown was a result of a thermal overload condition, allow the amplifier
to cool down before attempting to restart.
• If the shutdown was a result of an input overload. or speaker short circuit, be
sure to correct the condition before restarting. The amplifier can be restarted by
turning the remote power OFF and then ON again.
To Next Page
Loading...
