Pyle PLMRA210BT - Page 3

Elite Series Waterproof Amplifiers
PLMRA210BT - System Layout
PLMRA210BT
1
RCA
(Low Level Input)
This unit Is provided with RCA Input jacks. Couple the RCA
Input with the car stereo or equalizer outputs using RCA type
connector cables.
2
Input Gain
Control
These are NOT Your amplifiers volume controls. They are a
sophisticated device which is to be utilized when matching the
Input signal of your head unit or equalizer to their amplifier.
3
Bridging
Capability
Can be bridged to a high power one channel unit. Make sure
that you have a speaker or series of speakers on the bridged
channel capable of handling at least 200 Watts of RMS power.
4
Speaker
Connectors
(High Level Input)
This unit is provided with terminal inputs. Couple the terminals
with a standard
car stereo output system wither common
ground to floating ground type originally output to speakers.
The speaker wires of the car stereo should be connected to "L·"
and "R·" terminals respectively. H the car stereo comes out
with three wires only, connect the "COMMON" wire to both
"L" and "R" input of the amplifier.
5
Power Supply
Terminal
Connect the + 12V DC power supply Into the terminal by lugs
and screws accessible at the panel of this amplifier.