Pyle PSBV200BT - Specifications and Placement; Specifications; Placing the Unit

Take advantage of 3D stereo technology, you can listen to surround
sound without extra speakers. Placing your system as follows, and turn
on BASS +/- or TRE +/- effect by pressing these Buttons on the remote
control, you will get the surround sound effects.
PLACING THE UNIT
Power Supply----------
Peak RMS Output--------------------------------------------------------------------300W
Input Sensitivity---------------------------------------------------------- 400mV±50mV
S/N(A Weight)---------------------------------------------------------------------- 80dB
Channel Separated Rate(1KHz)----------------------------------------------- 40dB
Woofer Impedance----------------------------------------- -----------------------8 Ohm
Tweeter and full range speaker Impedance----------------------------------4 Ohm
THD(1KHz, 1W, 8Ohm)---------------------------------------------------------- 0.5%
Frequency Response------------------------------------------------------ 20Hz-20KHz
Dimensions(WxDxH)------------------------------------------------- 605x250x120MM
Weight---------------------------------------------------------------------------------5.3KGS
-----------------------------------------
-
-
-
--
-
-
-
AC:100~120V, 50/60Hz
NOTE: Specifications are subject to change for improvement without
prior notice.
SPECIFICATIONS