Pyle PSBV400 - System Mounting Diagram and Steps; System Connections; Power and External Device Connections

SYSTEM MOUNTING DIAGRAM
~-- -_ - ------->,<I
1. Choose the pos/tion where you want to mount the sound bar. Mark as
Fogure 1 Inclcat ...
...L;I,--- - ..... m - -~I
2. Use a drill(7mm drill bit) to make holes according to the marks in figure 1.
3. Put 1he plaatlc anchonllnto 1he ~ and savw1he wall plata onto the wall.
(NOTE:
Verify the 1bdng of wall plate in a proper way).
4. Aim the sound bar mount toward the wall plate to hang the sound bar on
the wall.
(NOTE: Verily the mounting of sound bar to avoid an accident)
o
SYSTEM CONNECTIONS
1. CONNECT POWER SUPPLY
Insert 1he power plug Into. wall 8OCk8l Make ... '" f'....
the voltage marKed at the rear panel is same as . . ~
your AC power. 00 not operate wtth wet hands to Soc:kaI ~ . '
avoid electric shock. I ~
-~ ~
2. CONNECT WITH PCIMP3
To listan 1he sound source from PC (Computer) or MP3 Players, connect
the unit with the extemaI device as below:
' 0 -
~ i- '
3.5mm mini plug
connection cable
•
•
~ M~
OR
PC