PWMA200
(single channel main frame) standard match
1.
One set
of
main frame.
2.
Apiece
of
Lavalierwireless MIG with transmitter
3.
One headset MIG.
4.Wired
microphone
Note:
I.Lavalier
or
handheld wireless microphones
for
custome~s
optional.
2.The
same channel microphones can't work at the same
time
in
single
channel
receiver.
Operation
of
the
system
System
operation
on
AC
Po~
1.
Plug
in
theAG
power to the
poweroutletfrom
a power source. Make sure
you
are
using
the correct voltage when
you
plug
in
the
system
toAC
power.
2.
Switch the main power ON, the LED on the body will be lit. After using the
sytem, make sure to turn the main power off to avoid the battery built-in damaged.
3.
When
theAG
power suddently cut
off,
the built-in battery will power the system
to work in DG power no delay.
4. Fully hang up the antenna
of
the main frame to achieve the widest service
range
of
the wireless MIG,
or
to
getlhe
best result
of
radio.
If
the main receiver
meets the same
or
similar
channel
strong
interference
of
the
wireless electric
wave,
it
occurs
the
noisy
voice
or
interuption
phenomenon.
At
this
time,
adjust
the antenna to reduce
or
delete the interference.
5.
Adjustlhe
Volume with the control knob to
getlhe
perfect sound.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
