16 © 2000 Directed Electronics, Inc. Vista, CA
on-board dual stage shock sensor
There is a dual-stage shock sensor inside the control unit. Adjustments are made via the rotary control as indi-
cated in the diagram. Since the shock sensor does not work well when mounted firmly to metal, we do not
recommend screwing down the control module. The full trigger of the on-board shock sensor reports Zone 2. See
the Table of Zones section of this guide.
NOTE: When adjusting the sensor, it must be in the same mounting location that it will be after
the installation is completed. Adjusting the sensor and then relocating the module requires read-
justment.
optional sensor harness, 4-pin connector
The four-pin sensor harness is optional, and is not included with this unit.
These wires supply constant 12 volts and ground to the optional sensor.
These wires are multiplex inputs. If a (-) input of less than 0.8 seconds is supplied to either wire, the Warn-Away
response will occur. A (-) input of longer than 0.8 seconds to either wire will initiate the triggered sequence and
report Zone 4.
BLUE, GREEN
RED, BLACK
To Next Page
Loading...
Need help?
General
