28 © 2000 Directed Electronics, Inc. Vista, CA
rapid resume logic
The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored. This also applies to the VRS sequence. If the unit loses power at any time during the VRS sequence,
it will automatically resume the VRS full trigger sequence when the unit is powered back up.
long term event history
The system stores the last two full triggers in memory. These are not erasable. Each time the unit sees a full
trigger, the older of the two triggers in memory will be replaced by the new trigger. To access long term event
history:
1. With the ignition off, press and HOLD the Valet
®
/Program switch.
2. Turn on the ignition.
3. Release the Valet
®
/Program switch.
4. Press and release the Valet
®
/Program switch within 5 seconds. The LED will flash in groups
indicating the last two zones that triggered the unit. The LED will flash for one minute or
until the ignition is turned off.
NOTE: The Warn Away
®
triggers are not stored to memory and will not be reported.
To Next Page
Loading...
Need help?
General
