© 1995,1997 Directed Electronics, Inc. Vista, CA 11 97N437.597
H1/11 RED
(+)12V constant power input: Before connecting this wire, remove the supplied fuse. Connect to the battery
positive terminal or the constant 12V supply to the ignition switch as described on Page 5.
NOTE: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 10A fuse in the
harness for this purpose. This fuse protects the module itself.
H1/12 RED/WHITE
channel 2, 200mA (-) output: When the system receives the code controlling channel, for longer
than 1.5 seconds, the red/white will supply an output as long as the transmission continues. This is often used to
operate a trunk/hatch release or other relay-driven function.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transistorized output
can only supply 200 mA of current, connecting directly to a solenoid, motor, or other high-current device will
cause it to fail.
(+) 12V CONSTANT FUSED
RED/WHITE H1/1
FUNCTION 2 OUTPUT
(+)12V IF (+) SWITCHED
(-) GROUND IF (-) SWITCHED
SWITCHED TRUNK RELEASE WIRE
87
87A
85
86
30
RED/WHITE H1/12
CHANNEL 2 OUTPUT
PLUG-IN LED AND VALET
®
/ PROGRAM SWITCH
These plug into the module. The Status LED plugs into the small two-pin socket, while the Valet
®
/Program Switch
should be plugged into the larger blue two-pin connector. The Status LED fits in a 9/32" hole.
Status LED Valet
®
/Program Switch
GREEN
(-) Multiplex input: Inputs shorter than .8 seconds will trigger the Warn Away
®
response, while inputs longer
than .8 seconds will trigger full alarm sequence and report zone four. If installing an optional DEI
®
dual stage sensor,
connect to the GREEN wire as shown below. The diagram below eliminates the need for diodes to isolate the sensors,
as well as providing a seperate zone for each sensor.
Diagram for adding optional DEI
®
dual stage sensor to GREEN wire (zone 4)
BLUE
(-) Multiplex input: Inputs shorter than .8 seconds will trigger the Warn Away
®
response, while inputs longer than
.8 seconds will trigger full alarm sequence and report zone two.
RED, BLACK
: RED is (+)12V constant, BLACK is (-) ground. Do not use these for anything besides the plug in
shock sensor.
FOUR-PIN SHOCK SENSOR HARNESS
xx
CUT
BLUE WIRE OF PRE-
WIRED PLUG
GREEN WIRE OF PRE-
WIRED PLUG
BLUE WIRE FROM PLUG-
IN SHOCK SENSOR
GREEN WIRE FROM
PLUG-IN SHOCK SENSOR
BLUE AND GREEN WIRES
FROM DEI
®
DUAL STAGE
SENSOR
To Next Page
Loading...
