© 1995,1997 Directed Electronics, Inc. Vista, CA 18 97N437.597
OPERATING-SETTINGS LEARN ROUTINE™
Many of the operating settings of this unit are programmable. They can be changed whenever necessary through a
computer-based Learn Routine™. The Valet
®
/program push-button switch, plugged into the blue port is used together
with a programmed transmitter to change the settings. To program settings remember: Door, Key, Choose, Transmit
and Release.
1. Door Open a door. Either the H1/5
GREEN
or the H1/7
VIOLET
door
trigger wire must be connected for the control unit to “see” an
open door.
2. Key Turn the ignition on and then back off. The H1/9 YELLOW
switched ignition input must be connected.
3. Choose Within 15 seconds, press and release the Valet
®
/Program
button the number of times corresponding to the number of
the desired feature (see the chart below). The one chirp
settings below are the factory default settings, except where
indicated by bold text.
Feature Number One-chirp Setting Two-chirp Setting
1 Active arming Passive arming
2 Arm/disarm chirps on Arm/disarm chirps off
3 Ignition-controlled door locks Standard door locks
4 Active locking only Passive locking
5 Panic with ignition on No panic with ignition on
6 0.8 second door lock pulses 3.5 second door lock pulses
7 Forced passive arming on Forced passive arming off
8 Automatic engine disable on Automatic engine disable off
9 VRS
®
enabled VRS
®
disabled
10 Code-Hopping™ on Code-Hopping™ off
11 Siren Horn honk
To Next Page
Loading...
