© 1995,1997 Directed Electronics, Inc. Vista, CA 17 97N437.597
TWO-VEHICLE OPERATION WITH SINGLE TRANSMITTER
You can get two-vehicle operation with the transmitters that come with the system. However, you cannot use
all the auxiliary channels of the system (or all the auxiliary channels of the other system), unless using a
485T 4-button
transmitter.
Here's what to do:
1. Using Learn Routine™, program Button I into system # 1 as the arm/disarm button. Do this with all
four remotes.
2. Do the same with system # 2, except program Button II of all four remotes as the arm/disarm button.
If using DEI
®
485T four-button remotes,
all auxiliary channels are available on both vehicles. Before program-
ming, make a list of all channels on each vehicle, and decide which button(s) should control which channel.
For example, if you wanted the top two buttons to control vehicle # 1 and the bottom two buttons to control
vehicle # 2, here is how each system would be programmed:
Vehicle # 1:
Button I = arm/disarm.
Button II = trunk release/Silent Mode™.
Button I+II = channel three.
Vehicle # 2:
Button III = arm/disarm.
Button IV = trunk/release/Silent Mode™.
Button III+IV = channel three.
To Next Page
Loading...
Need help?
General
