How to turn on steady audio beep on Q'STRAINT?
The only way to turn on the steady audio beep on your Q'STRAINT device after it’s been turned off is to reset the Docking System by turning the vehicle off and then back on.
What to do if Q'STRAINT Docking Station does not open with Dash Control/aux release switch?
If the Q'STRAINT docking system doesn't open when you use the Dash Control or auxiliary release switch, check that the voltage supplied to the QLK system is more than 12V when QLK is activated. Also, ensure that the docking bolt/bracket isn't applying pressure to the locking pawl.
How to manually release a wheelchair from Q'STRAINT Docking Station?
To manually release the wheelchair from the Q'STRAINT Docking Station, push the Manual Release Lever. This will open the Locking Pawl and release the wheelchair.
Why is the green light on my Q'STRAINT Docking Station Dash Control not turning on?
If the green light on the Q'STRAINT Docking Station Dash Control won't turn on, it could be because the wheelchair isn't fully secured, meaning the Locking Pawl is still open. Alternatively, the Dash Control Wire Harness might not be properly connected to the Electrical Control Module (ECM). Ensure the wheelchair is secured, and check the connection of the Dash Control Wire Harness to the ECM.
What to do if the red light on Q'STRAINT Docking Station turns on and off?
If the red light on your Q'STRAINT Docking Station Dash Control turns on and then off, it means the wheelchair isn't secured in the Docking System, and the Locking Pawl is still open. Make sure to properly secure the wheelchair in the Docking System.
How to fix Q'STRAINT Docking Station if the dash control is not working?
If the Dash Control of your Q'STRAINT Docking Station is not working, check that the Dash Control Wire Harness is connected to the Electronic Control Module (ECM). Also, ensure that the surface is flat, as any curvature can affect the Dash Control.
How do I turn off the steady audio beep on Q'STRAINT?
To turn off the steady audio beep on Q'STRAINT, press the Mute Button. This will stop the beep and illuminate the solid Red Light.
What to do if I can't release QLK via Dash Control on Q'STRAINT?
If you keep attempting to release the QLK via the Dash Control without success on your Q'STRAINT system, do not persistently keep attempting to unlock it this way or via the auxiliary release switch. Instead, release the wheelchair brakes, drive into the dock, and attempt to release the QLK again. This should relieve any friction caused by the wheelchair bracket acting on the locking pawl.
How to turn off steady audio beep on Q'STRAINT?
To turn off the steady audio beep on your Q'STRAINT device, press the Touchable Surface to mute it.
Why are all the lights off on my Q'STRAINT Docking Station dash control?
If all the lights are off on the Dash Control of your Q'STRAINT Docking Station, it means the Locking Pawl is open, and the wheelchair isn't secured in the Docking System. Secure the wheelchair in the Docking System.
General| Brand | Q'STRAINT |
|---|---|
| Model | QLK-150 |
| Category | Wheelchair |
| Language | English |
To Next Page
