Q'STRAINT QLK-150 - Installation Instructions Manual

INSTALLATION INSTRUCTIONS
INVACARE TDX SP2 NARROW
READ ALL INSTRUCTIONS PRIOR TO INSTALLATION
• This is a comprehensive step-by-step instrucon guide on how to install the QLK-150 Invacare TDX SP2 Narrow Wheelchair Bracket.
• Make sure to read, understand and follow all these instrucons.
• To address any quesons contact the nearest Q’Straint® oce.
• All deviaons and alteraons from these instrucons MUST be reported to both your supervisor and Q’Straint®.
• For installaon of the QLK Docking system, please refer to the separate Installaon Instrucons and the Use and Care Manual.
IMPORTANT SAFEGUARDS AND WARNINGS
SAVE THESE INSTRUCTIONS
• All equipment and components MUST be installed and serviced
by an experienced and trained technician.
• The QLK-150 Wheelchair Docking System complies with all
applicable requirements of ADA, FMVSS, CMVSS, SAE J2249,
CSA Z604, AS2942, ISO 10542-1 and ANSI/RESNA WC-4
SECTION 18.
• This System is a complete integrated system, do not alter or
modify it in any way and do not interchange or substute any
components. Any deviaon from these recommendaons is the
responsibility of the installer.
• The QLK-150 Docking System, bracket and its components
MUST be regularly inspected, cleaned and maintained.
• Do NOT aempt to repair, adjust, or modify any component(s) of
the QLK-150 system or bracket without consulng a Q’Straint®
representave.
• The QLK-150 Wheelchair Docking System should not be
operated by anyone who does not have full comprehension of
how the System works or if the System is not working properly.
• The QLK-150 Wheelchair Docking System, bracket and all
system components including oor and wall anchorages MUST
be replaced aer a vehicle collision
• The QLK-150 Wheelchair Docking System MUST be installed
with a compliant occupant restraint system (shoulder and lap
belt).
• Broken and worn components MUST be replaced.
• All damages and defects MUST be reported to both your
supervisor and Q’Straint®.
• Only use Q’Straint® components with this system, including
hardware and wheelchair interface bracket unless otherwise
stated.
• Q’Straint wheelchair brackets and QLK docking staon have
been designed and tested as a system, for use with specic
wheelchairs.
• Q’Straint supplies all the components/hardware required to
install the system so the conguraon is the same as that tested
and set out in the individual installaon instrucons.
• Occasionally, wheelchairs may have addional components
installed which are not detailed in our installaon instrucons
and which may need to be temporarily removed in order to
gain access to xing holes or support frames to enable the
aachment of the wheelchair bracket.
• It is the responsibility of the installer to ensure that all such
wheelchair component(s) are put back in their original locaon
using the original xings or xing of the same size and grade.
• Each wheelchair should be test driven aer tment of the
bracket, to ensure it is funconing correctly.