DPI SERIES USER MANUAL
11
Model DPI10 DPI15 DPI20 DPI30 DPI40
Min. output power per channel into 2 ohms 500 W 900 W 1200 W 1600 W 2200 W
1 kHz sine wave, THD < 1%, both channels driven
Min. output power per channel into 4 ohms 300 W 500 W 800 W 1100 W 1500 W
1 kHz sine wave, THD < 1%, both channels driven
Min. output power per channel into 8 ohms 200 W 330 W 450 W 600 W 800 W
1 kHz sine wave, THD < 1%, both channels driven
Min. output power in bridge mode into 4 ohms 1000 W 1800W 2400 W 3200 W 4400 W
1 kHz sine wave, THD < 1%
Min. output power in bridge mode into 8 ohms 600 W 1000 W 1600 W 2200 W 3000 W
1 kHz sine wave, THD < 1%
Typical THD+N < 0.02 %
1 KHz -3dB output power
SMPTE intermodulation distortion < 0.05 %
60 Hz - 7 KHz 4:1 at -3dB output power
Dynamic intermodulation distortion < 0.05 %
30 KHz bandwidth at -3dB output power
Frequency range + 0 dB / - 0.8 dB
20 Hz - 20 kHz at nom. output power
Small Signal Frequency response 5 Hz - 50 kHz
-3dB; Load impedance 2 - 16 Ohms
Large Signal Bandwidth 35 kHz
Rise time < 10 µs
Damping factor > 3000 (EFL used)
1 KHz referred to 8 ohms
Voltage gain +36 dB
Level controls full cw
Noise interference < -105 dB
22 Hz - 22 KHz rms A weighted, referred to nom. output power
Crosstalk < -70 dB
1 KHz / 8 ohms
Input CMRR > 80 dB
100 Hz
Output DC offset voltage < ±25 mV
Input impedance 10 Kohms unbalanced / 20 Kohms balanced
Input connectors 1/4” phone jack / XLR compound receptacle, parallel XLR male
parallelled Phoenix® screw terminals
Output connectors 1 x 4-pole Speakon per channel / 1 x 4-pole Speakon for bridge
parallelled Phoenix® 4 mm² screw terminals
Cooling Forced cooling with 2 vari-speed fans / front to rear airow
Mains supply 115 V / 230 V ±10% AC 50/60 Hz
Dimensions Width: 482 mm, Height: 88.9 mm, Depth: 350 mm
(mounting base to connector panel)
Net weight 13.5 kg 15 kg 16 kg 18 kg 20 kg
Shipping weight 16.3 kg 18 kg 19 kg 21 kg 23 kg
Standards Safety: EN60065 EMC: EN55103-1/EN55103/2/E2/E3
Note: Distortion measurements with AES-17 low pass lter.
8. Specications