To Next Page

To Previous Page

Manual for Advance 6T series

LogoEasy

When you power on or reset your system, the picture shown below will be displayed on

the screen.

You can use CBLOGO.EXE (included in the QDI Driver CD 2000) to replace it by any other

logo which you prefer.

Please follow the steps to use CBLOGO.EXE Utility:

1. Copy CBLOGO.EXEand AWDFLASH.EXE from the directory \Utility located on

QDI Driver CD 2000 to your hard disk.

2. Get the BIOS file from AWDFLASH.EXE or Download the BIOS file from the Website

(http://www.qdigrp.com) and copy the BIOS file(xxxxxx.bin) to your hard disk.

3. Boot the system into DOS environment, Put your favor picture into BIOS file by

CBLOGO.EXE command. For example: CBLOGO.EXE xxxxxx.bin myphoto.bmp

4. Flash the BIOS to motherboard by AWDFLASH.EXE. For example: AWDFLASH

xxxxxx.bin

Reboot the system, you can see the new picture displayed on the screen. If you require

more parameters information concerning CBLOGO.EXE, please refer to the online help. If

you dont prefer the logo displayed on the screen during bootup, set the Show Bootup

Logo option as Disabled in the ADVANCED BIOS FEATURES  section of the BIOS.

* We reserve the right of modifying the default full-logo of QDI without further

notification.

Questions and Answers:

Need help?

Do you have a question about the QDI Advance 6T and is the answer not in the manual?

QDI Advance 6T Specifications

General