Name: QHYCCD QHY183C
Brand: QHYCCD
Rating: 4 (1 reviews)

To Next Page

To Previous Page

QHY183C

05 Use QHY183C in EZCAP_QT

EZCAP_QT is a software made by QHYCCD. This software has the basic capture function for

QHYCCD deep sky cameras. You can use this QHY183C camera in this software. You can download

it here: http://www.qhyccd.com/MediumCOLDMOS.html

1. Install EZCAP_QT software.

2. Connect QHY183C USB cable and also the 12V power supply cable

3. Run EZCAP_QT. Select "Connect" in Menu->Camera. If the camera is successfully connected.

The title of EZCAP_QT will display the camera firmware version and the camera ID.

4. In Menu->Camera Setup, Click "Temp Control" and set the CMOS sensor temperature. You

can enable the "Auto Control" and set the target temperature. For example here we set the

temperature to -10C. The CMOS temperature will come to -10C very fast (in about 2-

3minute). If you want to close the TEC, you can select "TEC OFF". If you just want to set the

TEC power but not the temperature. You can select "Manual" and then set the percent of the

TEC power.

5. You can use the preview tab to do preview. And use the focus tools to do focus. Then use the

capture tab to capture image. Here is a typical dark image at 60sec exposure, -10C. Stretch to

full range.

Questions and Answers:

Need help?

Do you have a question about the QHYCCD QHY183C and is the answer not in the manual?

QHYCCD QHY183C Specifications

General