70
3. Filter Installation: Insert the filter into the machine, and push the two hooks of the
filter in place.
STORAGE
If the machine will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the container. Allow the container and
the dehumidifier to dry completely.
2. Clean the air filter.
3. Store the device in a dust-free location, preferably covered with a sheet of plastic.
TROUBLE SHOOTING
Check the following before contacting technical support:
Failure Potential causes of failure Solution
The machine doesn't
work.
Is the power line properly con-
nected??
Connect the plug and socket
well.
Is the full water indicator light?
(water tank full or not put in
place)
Drain the water in the tank and
put it in place.
Is the room temperature is above
35 degrees or under 5 degrees?
The protection device is started
and the machine cannot work.
Dehumidification func-
tion can not start.
Is the filter blocked?
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
Is the air inlet or outlet blocked?
Remove the obstruction from the
air inlet or outlet.
Without wind Is the filter plugged?
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
It's noisy at work?
Is the machine tilted?
Move the machine to a flat,
strong position.
Is the filter blocked?
Clean the filter screen according
to the cleaning instructions of
dehumidifier.
E1 Code
Coil sensor short circuit or open
circuit
Check whether the line is loose
or replace the coil sensor.
CONDITIONS OF WARRANTY
There is a two-year warranty on your dehumidifier from the date of purchase. All material
or manufacturing defects will be repaired free of charge.
4
To Next Page
Loading...
Need help?
General
