Qlima RG10 - Page 24

To Next Page

To Previous Page

1. ON/OFF - Turns the unit on or off.

3. SET - Scrolls through operation functions as follows: Fresh > Sleep > Follow Me > AP mode > Self

clean... . The selected symbol will ﬂash on the display area, press the OK button to conﬁrm.

5. FAN SPEED - Selects fan speeds in the following order: AUTO > LOW > MED > HIGH. NOTE: Holding this

button down for 2 seconds will activate Silence feature.

6. SWING - Starts and stops the horizontal louver movement. Hold down for 2 seconds to initiate vertical

louver auto swing feature.

7. MODE - Scrolls through operation modes as follows: AUTO > COOL > DRY > HEAT > FAN. NOTE: HEAT

mode is not supported by the cooling only appliance.

8. SLEEP - Saves energy during sleeping hours.

9. OK - Used to conﬁrm the selected functions.

10. TIMER - Set timer to turn unit on or off.

11. SHORTCUT - Used to restore the current settings or resume previous settings.

12. CLEAN - Used to start/stop the Self Clean or Active Clean function.

13. LED - Turns indoor unit’s LED display and air conditioner buzzer on and off (model dependent), which

create a comfortable and quiet environment.

14. TURBO - Enables unit to reach preset temperature in shortest possible time.

NOTE: Press together and buttons at the same time for 3 seconds will alternate the temperature

display between the ºC and ºF.