134
Fig. 6.1
For Multi-type models:
One-twin One-three
2. Do not remove the plastic seals trom the outdoor unit and the appropriate refrigerant pipes until
immediately before you con neet them, Fig.6.2
Fig. 6.2
3. Align the refrigerant pipes correctly so that they line up with the valves and are not stressed. Place
the screw connector on the refrigerant line just on to the thread on the outdoor unit and
tighten the first few threads by hand, Fig.6.3.
NOTE: The refrigerant pipes must be connected to the valves on the outdoor unit with as
little stress as possible.
IMPORTANT: Before you continue, it is essential that you read the following instructions carefully.
4
To Next Page
Loading...
