Qlogic 5800V Series Installation Guide

4–Diagnostics/Troubleshooting
Power-On Self Test Diagnostics
4-10 59265-02 B
Excessive Port Errors
The switch can monitor a set of port errors and generate alarms based on
user-defined sample windows and thresholds. These port errors include the
following:
 Cyclic redundancy check (CRC) errors
 Decode errors
 ISL connection count
 Device login errors
 Device logout errors
 Loss-of-signal errors
Port threshold alarm monitoring is disabled by default. For information about
managing port threshold alarms, refer to the QLogic 5800V Series Fibre Channel
Switch Command Line Interface Guide.
If the count for any of these errors exceeds the rising trigger for three consecutive
sample windows, the switch generates an alarm, disables the affected port, and
changes the port operational state to down. Port errors can be caused by the
following:
 Triggers are too low or the sample window is too small
 Faulty Fibre Channel port cable
 Faulty SFP
 Faulty port
 Faulty device or adapter
Review the event browser to determine if excessive port errors are responsible for
disabling the port. Look for a message that mentions one of the monitored error
types, indicating that the port has been disabled, and then do the following:
1. Examine the alarm configuration for the associated error using the Show
Config Threshold command. Refer to the Show Config Threshold command
in the QLogic 5800V Series Fibre Channel Switch Command Line Interface
Guide. Are the thresholds and sample window correct?
 Yes—Continue.
 No—Correct the alarm configuration. If the condition remains,
continue.

Qlogic 5800V Series Specifications

General

Brand	Qlogic
Model	5800V Series
Category	Switch
Language	English