Qlogic Fibre Channel Adapter

Configuration
Identifying QLogic FC Adapters on VMware ESX
FC0054606-00 A 3-3
A
2. To list the QLogic storage adapters present on the system, run the following
command:
ls /proc/scsi/qla2300
An example output may be:
# ls /proc/scsi/qla2300/
1 2 3 4 5 6 HbaApiNode
3. To view additional details, run the following command:
cat /proc/scsi/qla2300/<adapter_number>
Where <adapter_number> is one of the adapter numbers shown in
Step 2.
This command lists the firmware revision, driver revision, and the boot code
version, as shown in Figure 3-2.
Figure 3-2 Finding Adapters on VMware ESX