Troubleshooting
Troubleshooting with Driver Logs
A-6 FC0054606-00 A
S
"scsi(%d): 64 Bit PCI Addressing Enabled"
Driver is reporting that it has configured the adapter for 64bit PCI bus transfers.
"scsi(%d): Verifying loaded RISC code..."
Driver is reporting that it has verified the RISC code and it is running.
"scsi(%d): Verifying chip..." extended"
Driver is reporting that it has verified the chip on the adapter.
"scsi(%d): Waiting for LIP to complete..."
Driver is reporting that it is waiting on the firmware to become ready.
"scsi(%d): LIP occurred, ..."
Driver received a LIP async event from the firmware.
"scsi(%d) LOOP UP detected"
Driver received a loop up async event from the firmware.
"scsi(%d) LOOP DOWN detected"
Driver received a loop down async event from the firmware.
"scsi(%d): Link node is up"
Driver received a point-to-point async event from the firmware.
"scsi%d: Topology - (%s), Host Loop address 0x0"
Indicates the firmware connection type. %s will be one of the following: FL-PORT, N-PORT, F-PORT,
NL-PORT, and host adapter loop ID.
"scsi%d : QLogic XXXXXX PCI to Fibre Channel Host Adapter: ... " Firmware
version: 4.04.06, Driver version 7.08vm62"
Driver is reporting information discovered during its initialization. This information includes the board ID,
firmware version, and driver version.
"qla%d Loop Down - aborting ISP"
Indicates driver is attempting to restart the loop by resetting the adapter. Usually done by the driver when
sync is not detected by the firmware for a long time (4+ minutes), and usually means that the adapter
port is not connected to the switch or loop.
"scsi(%d): %s asynchronous Reset."
Driver received an async reset event from the firmware. %s indicates the function name.
"qla2x00: ISP System Error - mbx1=%x, mbx2=%x, mbx3=%x"
Table A-6. Common Driver Log Messages (Continued)
To Next Page
Loading...
Need help?
General
