Troubleshooting
Troubleshooting with Driver Logs
FC0054606-00 A A-9
A
"WARNING qla2x00: couldn't register with scsi layer\n"
Indicates the driver could not register with the SCSI layer, usually because it could not allocate the mem-
ory required for the adapter.
"WARNING scsi(%d): [ERROR] Failed to allocate memory for adapter\n"
Indicates the driver could not allocate all the kernel memory it needed.
"WARNING qla2x00: Failed to initialize adapter\n"
Indicates that a previously occurring error is preventing the adapter instance from initializing normally.
"WARNING scsi%d: Failed to register resources.\n"
Indicates the driver could not register with the kernel.
"WARNING qla2x00: Failed to reserve interrupt %d already in use\n"
Indicates the driver could not register for the interrupt IRQ because another driver is using it.
"WARNING qla2x00: ISP Request Transfer Error"
Driver received a Request Transfer Error async event from the firmware.
"WARNING qla2100: ISP Response Transfer Error"
Driver received a Response Transfer Error asynchronous event from the firmware.
"WARNING Error entry invalid handle"
Driver detected an invalid entry in the ISP response queue from the firmware. This error will cause an
ISP reset to occur.
"WARNING scsi%d: MS entry - invalid handle"
Driver detected a management server command timeout.
Table A-6. Common Driver Log Messages (Continued)
To Next Page
Loading...
Need help?
General
