User’s Guide—25Gb Intelligent Ethernet Adapter
QL45212
iv BC0154503-00 C
Added reference on CentOS on Step 2 and Step 3,
under “For RHEL”
“Installing Linux Drivers Using the src RPM Pack-
age” on page 14
Updated Step 1 command
rpm -ivh kmod-qlgc-fastlinq-<ver-
sion>.<arch>.rpm to
rpm -ivh qlgc-fastlinq-<ver-
sion>.<arch>.rpm
“Installing Linux Drivers Using the kmp/kmod RPM
Package” on page 15
Added reference to CentOS on Step 2, under “For
RHEL”
“Installing Linux Drivers Using the TAR File” on
page 15
Added note on CentOS. “Installing the Linux Drivers without RoCE” on
page 11
“Installing the Linux Drivers with RoCE” on
page 16
Deleted reference to “modprobe -r qed and
modprobe -qede.”
Added make install_libeqdr.
“To install Linux drivers in an in-box OFED environ-
ment:” on page 16
Updated parameter content and description. Table 3-2 on page 17
Added “See Step 7 on Verifying the RoCE Configu-
ration on Linux on page 59 for more information.”
“Statistics” on page 18
Updated reference from “click View Log” to “click
View Installation Log” on Step 9, first bullet. Also
updated second bullet from “click OK”, to “Click
CLOSE”.
“Running the Dell Update Package in the GUI” on
page 19
Updated screenshot for Step 8, Step 9. Figure 3-7 on page 23
Figure 3-8 on page 24
Removed redundant content from “Installation
Options” topic.
“Installation Options” on page 24
Created new topic “Updating Dell DUP Using .BIN
File”.
“Upgrading Firmware” on page 31
Updated note on Step 3. “To enable NIC partitioning (NPAR), single root
input/output virtualization (SR-IOV), or both:” on
page 42
Added new paragraph and table on FEC Mode
options.
“NIC Configuration” on page 44
Added screenshot of partition configuration details
on Step 4.
“To configure the maximum and minimum band-
width allocations for each partition:” on page 46
Added RoCE v1 and v2 “Configuring RoCE” on page 48
To Next Page
Loading...
Need help?
General
