Qlogic QL45212 User Manual

6–Configuring RoCE
Preparing the Ethernet Switch
53 BC0154503-00 C
4. Verify the DCB map configuration. Priority group
Dell(conf-dcbmap-roce)# do show qos dcb-map roce
-----------------------
State :Complete
PfcMode :ON
--------------------
PG:0 TSA:ETS BW:40 PFC:OFF
Priorities:0 1 2 3 4 6 7
PG:1 TSA:ETS BW:60 PFC:ON
Priorities:5
5. Apply the DCB map to the port.
Dell(conf)# interface twentyFiveGigE 1/8/1
Dell(conf-if-tf-1/8/1)# dcb-map roce
6. Verify the ETS and PFC configuration on the port.
Dell(conf-if-tf-1/8/1)# do show interfaces twentyFiveGigE 1/8/1 ets
summary
Interface twentyFiveGigE 1/8/1
Max Supported TC is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
------------------------------------------------------------------------
0 0,1,2,3,4,6,7 40 - - - - ETS
1 5 60 - - - - ETS
2 - - - - - -
3 - - - - - -
Dell(Conf)#
do show interfaces twentyFiveGigE 1/5/1 pfc detail
Interface twentyFiveGigE 1/5/1
Admin mode is on
Admin is enabled, Priority list is 5
Remote is enabled, Priority list is 5
Remote Willing Status is enabled
Local is enabled, Priority list is 5
Oper status is init
PFC DCBX Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 65535 pause quntams
Application Priority TLV Parameters :
--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is enabled
Local FCOE PriorityMap is 0x0
Local ISCSI PriorityMap is 0x10
Remote ISCSI PriorityMap is 0x10
66 Input TLV pkts, 99 Output TLV pkts, 0 Error pkts, 0 Pause Tx pkts, 0 Pause Rx
pkts
66 Input Appln Priority TLV pkts, 99 Output Appln Priority TLV pkts, 0 Error Appln
Priority TLV Pkts

Qlogic QL45212 Specifications

General

Brand	Qlogic
Model	QL45212
Category	Adapter
Language	English