14 – Command Reference
Set Setup Callhome
59263-01 A 14-111
A
Examples The following is an example of the Set Setup Callhome command:
SANbox (admin) #> set setup callhome
A list of attributes with formatting and current values will follow. Enter a new
value or simply press the ENTER key to accept the current value. If you wish to
terminate this process before reaching the end of the list press 'q' or 'Q' and the
ENTER key to do so.
If either the Primary or Secondary SMTP Servers are enabled, the FromEmailAddress
attribute must be configured or the switch will not attempt to deliver messages.
Current Values:
PrimarySMTPServerAddr 0.0.0.0
PrimarySMTPServerPort 25
PrimarySMTPServerEnable False
SecondarySMTPServerAddr 0.0.0.0
SecondarySMTPServerPort 25
SecondarySMTPServerEnable False
ContactEmailAddress nobody@localhost.localdomain
PhoneNumber <undefined>
StreetAddress <undefined>
FromEmailAddress nobody@localhost.localdomain
ReplyToEmailAddress nobody@localhost.localdomain
ThrottleDupsEnabled True
New Value (press ENTER to accept current value, 'q' to quit):
PrimarySMTPServerAddr (IPv4, IPv6, or hostname) :
PrimarySMTPServerPort (decimal value) :
PrimarySMTPServerEnable (True / False) :
SecondarySMTPServerAddr (IPv4, IPv6, or hostname) :
SecondarySMTPServerPort (decimal value) :
SecondarySMTPServerEanble (True / False) :
ContactEmailAddress (ex: admin@company.com) :
PhoneNumber (ex: +1-800-123-4567) :
StreetAddress (include all address info) :
FromEmailAddress (ex: bldg3@company.com) :
ReplyToEmailAddress (ex: admin3@company.com) :
ThrottleDupsEnabled (True / False) :
Do you want to save and activate this Callhome setup? (y/n):
To Next Page
Loading...
Need help?
General
