Qlogic SANbox 5802V

6 – Port Configuration
Testing a Port
59263-01 A 6-15
A
Display Port Test Results
You can display the test status while the test is in progress by entering the
Test Status Port command in an Admin session as shown in the following
example:
SANbox (admin) #> test status port 1
Port Test Test Loop Test
Num Port Type Status Count Failures
---- -------- ---- ------ ----- --------
1 1 Offline Internal Passed 12 0
Cancel a Port Test
To cancel a port test that is in progress, enter the Test Cancel Port command.
SANbox #> show donor
Port Config Ext Credit Max Credit Donated Member of Valid Groups to
Number Type Requested Available to Port Donor Group Extend Credit
------ ------ ---------- ---------- ------- ----------- ---------------
0 GL 0 16 None 0 0
1 GL 0 16 None 0 0
2 GL 0 16 None 0 0
3 GL 0 16 None 0 0
4 GL 0 16 None 0 0
5 GL 0 16 None 0 0
6 GL 0 16 None 0 0
7 GL 0 16 None 0 0
8 GL 0 16 None 0 0
9 GL 0 16 None 0 0
10 GL 0 16 None 0 0
11 GL 0 16 None 0 0
12 GL 0 16 None 0 0
13 GL 0 16 None 0 0
14 GL 0 16 None 0 0
15 GL 0 16 None 0 0
16 GL 0 16 None 0 0
17 GL 0 16 None 0 0
18 GL 0 16 None 0 0
19 GL 0 16 None 0 0
20 G 0 16 None None None
21 G 0 16 None None None
22 G 0 16 None None None
23 G 0 16 None None None
Donor Group Credit Pool
----------- -----------
0 0