5 – Switch Configuration
Displaying Switch Information
59263-01 A 5-5
A
Elapsed Time Between Resets
The Uptime command displays the elapsed time since the switch was last reset
and the reset method. A hot reset or non-disruptive firmware activation does not
reset the elapsed time reported by this command. The following example displays
the time since the last reset.
SANbox #> uptime
Elapsed up time : 0 day(s), 2 hour(s), 28 min(s), 44 sec(s)
Reason last reset: NormalReset
Configuration Information
The Show Config command displays a variety of configuration information at the
port and switch levels. In addition to the basic switch configurations, the Show
Config command displays parameters that control how data is maintained in the
security and zoning databases. The Show Config command displays the following
types of information:
Switch Configuration Parameters
Zoning Configuration Parameters
Security Configuration Parameters
Refer to “Displaying Port Information” on page 6-1 for information about displaying
port configuration information.
To Next Page
Loading...
Need help?
General
