Important Tips:
(Please Read)
1. The clock can display in either 12 or 24 hour display format. In 12hr mode PM
is represented by (P) in the upper left corner.
2. The number of consecutive days to feed can be changed at any time but the
previous schedule will be replaced.
3. The feeding times and feeding volume can be changed at any time and the new
settings will be for the rest of feeding day’s schedule.
4. Once the schedule has started, the DAYS displayed will be reduced by 1 every
day at 0:00 (midnight) until the end is reached. It will then revert back to the
original number of set DAYS and the Feed Alarm will sound. Just press the START
key to start your original program/setting again.
5. If the timer icon is OFF and all numbers are flashing then no feeding schedule has
been set and need to set up again.
6. Only when CLOCK is pressed and the CLOCK icon on is the current time displayed.
7. When RED (LOW BATT) Light FLASHES, the batteries are low and must be
replaced. Change all the batteries ASAP. You need to reprogram all your settings
after you replace the batteries.
8. When the LCD display shows (Err), the food delivery door is not closing properly.
You need to remove any food that jams the door.
Turn the power off, remove all food and turn the feeder upside down.
Clean both doors hinges with a soft brush.
After cleaning turn the switch ON again and refill with food.
Note: You will have to reprogram all your original settings before you can use your
feeder again
Made in China
9
To Next Page
