QSC KLA181 - Attaching KLA181 Loudspeakers Together; Install KLA181 M10 KIT in Integrated Suspension Points

2
Attaching KLA181 Loudspeakers Together
1. Insertthesupplied6mmhexkeyintothehexsocket(Figure 1, 1)andmakesurethehexkeyisrotatedcompletelytotheUnlockposition.
2. PlaceaKLA181ontopoftherstonewiththeloudspeakersfacingthesamedirection.Makesurethatthefourfeet(2)onthetopKLA181nest
properlywiththefourfeetreceptacles(3)onthetopofthebottomKLA181.
NOTE: ThebottomportionofFigure 2showsthemotionofthehookduringthelatchingprocess.Thisisnotvisibleonthe
actualhardware.
3. Insertthe6mmhexkeyintothehexsocket(1)inthelowerKLA181andturnthekeyfullytotheLocked Position.Repeatfortheotherside.
a. IntheRetracted Position,youcannotseethehookintheviewholes.
b. WhenthehookreachestheUp Position,thehookalmostcompletelyllsthelargeviewing(2)holeatthetop.
c. Inthenal,LockedPosition,youcanseeasmallportionofthehookinthebottomofthelargeviewinghole(2).
Install KLA181 M10KIT in Integrated Suspension Points
NOTE: TheKLA181suspensionpointsaredesignedforusewiththe
eyebolts(M10X1.50,35mm–38mm)includedintheavailableaccessorykit
(modelnumber:KLA181M10KIT).
1. Usea6mmhexkeytoremovethefourhexscrewsfromthefourKLA181M10
installationpointsonthetopoftheloudspeaker.
2. Threadaneyebolt(1)intoeachofthethreadedinserts.
3. Tightentheeyeboltsuntiltheirshouldersaresnugagainsttheenclosure.
4. Continuetorotatetheeyeboltsuntiltheyreachthedesiredposition.Donotovertighten.
5. Theloudspeakersarereadyforsuspension.
— Figure 1 —
1
2
3
— Figure 2 —
Locked
Position
Up
Position
Retracted
Position
2
1
— Figure 3 —