QUAD 33 - Tape; Quad; Tape Adaptor Board

with the
same
type of
plug
should be checked
to
ensure
that the same connections
are used. The output of such
tuners
should
be suitable
for
the
Quad
33
input
of
l00mV
and
l0OK
ohms
(stereo)
or
l00mV
and
50K
ohms
(mono).
The mains
supply
for these tuners should
also be
taken from the
mains
outlet sockets
at the rear
of
the
Quad
33.
(See
Fig. l0).
WARNING
On no account should
the HT
ILT
lead
of earlier
Quad
tuners
be connected
to the
power
supplies sockets of the
Quad
33
control unit. If such
tuners are used a separute
power pack
must
be
provided.
Tape
Three essential
functions are
provided
for tape
recording:
(l)
to
provide
a
signal
of the right level
for recording,
not afiected by
any of the tone,
filter
or
volume
controls
and
without afiecting normal
listening;
(2)
to accept a signal
of any
likely level from the re-
corder
for
replay and subject this
to all
the
appropriate control
facilities, and
FIG. 8
TAPE ADAPTOR BOARD
(3)
to
monitor the signal
off
the tape
during
recording
without interrupting the
recording operation,
pro-
viding,
of
course, that
the tape
recorder
has a
monitor output.
Page Nine