Need help?Do you have a question about the QUAD 33 and is the answer not in the manual?
General| Signal to Noise Ratio | 70dB (phono), 80dB (line) |
|---|---|
| Frequency Response | 20Hz to 20kHz ±1dB |
| Total Harmonic Distortion | Less than 0.1% at 1kHz |
| Output | 500mV |
| Valve Complement | None (Solid State) |
| Input Impedance | 47k ohms (phono), 100k ohms (line) |
| Output Impedance | 100Ω |
| Input Sensitivity | 100mV (line) |
Connects the control unit output to the power amplifier using a 4-pin connector.
Connects loudspeakers to the power amplifier using appropriate speaker cable for phase.
Describes the 5-pin plug input and Disc Adaptor Board for various pickup types.
Explains how to check and ensure correct loudspeaker phasing for optimal stereo imaging.
To Next Page
