QuadTech Sentry Plus Series User Manual

Interface Page 73 of 85
3.5 S05 Foot Switch
The S05 Foot Switch provides hands-free remote testing capability. The spade leads on the S05
Foot Switch are connected (screwed) to the terminal strip on the rear panel of the Sentry Plus
Series instrument.
1. Connect (screw) the white wire/spade connector to the START terminal.
2. Connect (screw) the red wire/spade connector to the COM terminal.
Figure 3-9 illustrates this connection of the S05 Foot Switch to a Sentry 30 Plus instrument.
S05 Foot Switch
White
Wire &
Spade
to
Terminal
Strip:
START
Red
Wire &
Spade
to
Terminal
Strip:
COM
Terminal Strip rear of Sentry 30 Plus
HV OUTPUT
!
HIGH VOLTAGE
Max 5kVAC/6kVDC
RTN/LOW
!
CONT. CHECK OPTION
VOLTAGE SELECTOR
POLLUTION DEGREE 2
INSTA LLATI ON CATEGORY I I
WARNI NG: FOR C ONTINUED P ROTECTION
AGAINST FIRE HAZARD, REPLACE ONLY WITH
THE SAME TYPE AND RATING OF FUSE AS
SPECIFIED FOR THE LINE VOLTAGE BEING
UTILIZED.
CAUTION: NO OPERATOR SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
PERSONNE L.
90V - 110V ~
216V - 250V ~
198V - 242V ~
108V - 132V ~
3.15AT
250V
1.6AT
250V
INTER
LOCK
COM
START
RESET
69
15
100V/120V/220V/240V~
50/60Hz 300W MAX
MODEL NO.
SERIAL NO.
FAN 50
o
C AUTO ON/OFF
Figure 3-9: S05 Foot Switch

QuadTech Sentry Plus Series Specifications

General

Brand	QuadTech
Model	Sentry Plus Series
Category	Test Equipment
Language	English