page 2
This guide specifies how the Pro10 headset system should be installed and commissioned.
The LEDs on the base, registration point and headset use a sequence of colours and pulses to
indicate the status of the system and the item, which are explained in this guide.
Contents
Pre-Installation Procedure
Tools required to install Pro10 system page 3
Pro10 system components
Step 1 - Charging headsets
Step 2 - Pre-installation survey
Step 3 - Locating base stations
Step 4 - Conducting your range test page 5
Step 5 - Positioning the registration point
Installation Procedure
Step 6 - Installing base stations and registration point page 6
Step 7 – Connecting base stations and registration point page 7
Step 8 - Synchronising base stations
Step 9 - Setting up the charger page 8
Step 10 - Registering headsets
Step 11 - Testing the installation page 9
Appendix A - Headset battery fitting page 10
Appendix B - Headset functionality & system troubleshooting page 11
Appendix C - Pro10 products and codes page 12
Regulatory Notices page 13
To Next Page
Loading...
