To Next PageTo Next PageHow to fix a Qualcast QGTLi18 Trimmer that runs slowly?
If your Qualcast Trimmer runs slowly, check that the spool housing can rotate freely, and carefully clean it if necessary. Also, ensure that the cutting line does not protrude more than 9cm from the spool housing; if it does, cut it off so that it just reaches the line trimming blade.
What to do if my Qualcast Trimmer will not operate?
If your Qualcast Trimmer won't operate, first check the battery pack assembly to ensure it's correctly connected. Since the grass trimmer's operation depends on sufficient battery charge, ensure you charge the battery.
What to do if my Qualcast QGTLi18 is not cutting properly?
If the Qualcast Trimmer is not cutting properly, examine the cutting head's condition. If the cutting line is too short or the cutting head is damaged, replace it. Note: Do not use a damaged cutting head.
Why is my Qualcast QGTLi18 Trimmer battery not charging?
WARNING! Read all safety warnings and instructions. Failure to follow may result in electric shock, fire or serious injury.
Read instructions carefully, be familiar with controls and proper use. Never allow children or unfamiliar people. Operator is responsible for accidents.
Before use, inspect machine for damaged guards or shields. Never operate near people or pets.
Wear eye protection, use in daylight, switch on with hands and feet away from cutting means.
Appliance not for use by persons with reduced capabilities unless supervised. Children must be supervised.
Do not dismantle, short-circuit, expose to heat or fire, or subject to mechanical shock. Handle leaks carefully.
For cutting weeds, grass, and soft vegetation in hard-to-reach areas. For private domestic use only.
Explains warning symbols like general warning, CE conformity, sound power level, and bystander safety.
Lists all parts included in the package with corresponding numbers for identification.
General instruction to read all safety instructions before using the tool.
Charger and battery are designed to work together. Never insert metallic objects. Charge before first use.
Best performance at 18-24°C. Let hot battery cool for 30 mins. Use in well-ventilated area. Do not overcharge.
Instructions on how to switch the trimmer on and off using the safety lock-off button and trigger.
Check nylon lines, remove battery, press spool button, pull nylon. Install battery, switch on. Lengthened line cut by blade.
Adjust the angle of the auxiliary handle for ease of operation and to prevent loss of control.
Loosen locking sleeve, adjust pole length to body height, tighten sleeve securely.
Adjust the vertical angle of the trimmer head to fit trimming conditions using the tilt-adjustment pedal.
Set the cutting angle to 0 degrees and press the edging button to rotate the lower tube 90 degrees.
Always wear eye protection. Hold unit below waist level. Work from right to left. Use trimmer at a 15° angle.
Lines automatically elongate when the appliance is turned on. Ensure coil stops moving before turning on again.
Remove battery pack after use. Store in a dry, safe place. Use only manufacturer recommended parts.
WARNING! Switch off and remove battery before replacing spool. Do not stop cutting device with hands. Remove spool assembly.
Check spool housing, cutting line protrusion, cutting head condition, and battery pack for operational issues.
Provides model numbers, voltage, battery type, speed, cutting width, charger specifications, and noise/vibration data.
Dispose of waste battery-powered products responsibly. Check with local authority or retailer for recycling advice.
Dispose of the hedge trimmer and accessories in accordance with local recycling regulations.
Customer helpline details, email, and website for assembly, parts, and technical support.
Claims must be made within 24 months. Covers manufacturer defects under normal use. Excludes misuse or neglect.
General
