98
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Preparing to Operate the Cylinder Mower
Preparing to operate the rear roller cylinder mower
Always wear safety gloves when doing any work on the rear roller cylinder mower.
WARNING! Always unplug the power cord from the power source before doing any work on the
rear roller cylinder mower.
Step 1 Adjusting the cutting height
This Cylinder mower can be set to 3 positions of cutting height. Position 3 is the lowest cutting
height.
1. Pull the lever outwards from the machine and then select your required cutting height position
1-2-3.
2. Release the lever and then make sure that it is fully secured into the selected cutting position.
NOTE! Never use the lowest cutting height for the rst cut of the season or in drought conditions.
Cutting position Cutting height
1 18 mm
2 28 mm
3 38 mm
1
2
Step 2 - Switch on /off
CAUTION! For your safety, this tool is equipped with a double switch system. This system
prevents starting the tool inadvertently. You must press the switch lock button (A) rst before
pulling the switch lever (B).
WARNING! Never attempt to pull the switch level without pressing the switch lock button rst!
Preparing to Operate the Cylinder Mower
Step 3 - Adjusting the blade clearance
Cylinder mower blades act like a pair of shears and should be adjusted if the grass is not cut
cleanly and evenly.
1. Turn the mower upside down and using a screwdriver, turn each adjustment screw as shown
above, clockwise a little at a time.
A
B
C
D
Switching ON
1. Press the switch lock button (A).
2. Pull the switch lever (B) and release the switch button (A).
Switching OFF
Release the switch lever (B).
WARNING! Never adjust the blade while the machine is plugged into the main power source.
To Next Page
Loading...
Need help?
General
