1312
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
WARNING! Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed by an authorised service
centre or a similarly qualied specialist if you cannot solve the problem yourself!
Storage and Transportation
Cable tidy system
Handle positions storage
Transportation
1. Switch the product off and disconnect it from power supply before transporting it anywhere.
2. Always carry the product by the central carry handle.
3. Protect the product from any heavy impact or strong vibrations which may occur during
transportation in vehicles.
4. Secure the product to prevent it from slipping or falling over.
NOTE! Always carry the product by the central carry handle.
Suspected malfunctions, disturbances or damages are often due to causes that the user can
x themself. Therefore check the product using this section. In most cases the problem can be
solved quickly.
Problem Possible Cause Solution
Product does not
start
1. Not connected to power supply
2. Power connection is loosen
3. Other electrical defect to the
product
1. Connect to power supply
2.Connect the power supply and tool
well
3. Check by a specialist electrician
Product does not
reach full power
1. Extension cord not suitable for
operation with this product
2. Power source (e.g. generator)
has too low voltage
3. Machines internal wiring
damaged
1. Use a proper extension cord
2. Connect to another power source
3. Contact the customer helpline
Machine not cutting 1. Height of cut too low
2. Blades off cut
1. Increase height of cut (See --
Adjusting the cutting height)
2.Blades require adjustment (See—
Adjusting the blades clearance)
Machine leaves
ragged nish
1.Cutting blades blunt Blade require adjustment (See-
Adjusting the blades clearance)
Cutting blades not
rotating
1.Cutting blades obstructed
2.Belt is slipping or is damaged
1.Clear obstruction
2.Contact customer helpline
Excessive vibration/
noise
1.Cutting blades damaged
2.Cutting blades not adjusted
evenly
1.Contact customer helpline
2.Blades require adjustment(See-
Adjusting the blades clearance)
Rollers do not rotate Roller is blocked by debris Clean all roller slots
Troubleshooting
General Troubleshooting
Technical Data Table
WARNING! The vibration emission value during actual use of the tool can differ from the declared
value depending on the ways in which the tool is used. Identify safety measures to protect the
operator that are based on an estimation of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as the times when the tool is switched off and when
it is running idle in addition to the trigger time).
The sound intensity level for the operator may exceed 85dB(A) and ear protection measures are
necessary.
Technical Data
After use, wrap your extension cable around the cable hooks and secure the plug in place.
To release the extension cable for machine use, just rotate the cable hook .
Push the lower handle to the right and then rotate forward, make sure the lower handle is out of
the block position. Release the CAM levers and fold the handle down.
cable clip
Handle operating
position
Handle - park
position
To Next Page
Loading...
Need help?
General
