To Next Page

To Previous Page

Customer Helpline 0845 034 2279

www.gardenservicecentre.co.uk

Customer Helpline 0845 034 2279

www.gardenservicecentre.co.uk

Step 2 - Filling with Engine Fuel

Preparing to Operate the Lawnmower

Step 1 - Setting the Cutting Height

Operating the Lawnmower

WARNING! The blade can cause serious injury. Before adjusting the mower height, stop the engine

and wait for the mower blade to stop completely.

Pull the lever towards the wheel, then move it forward or backward to adjust the cutting height

Move it to any one of the 5 positions for the desired cutting height;

Release lever towards mower deck.

CAUTION! Always use clean, fresh unleaded petrol. Purchase fuel in quantities that can be used

within 30 days. Never mix oil with petrol.

CAUTION! Do not ll into the base of neck to allow for fuel expansion. Do not overll the fuel tank.

CAUTION! WARNING! Petrol is highly ammable and extreme precaution must be taken when

handling or working with it. Keep out of reach of children.

CAUTION! To prevent engine damage the engine is shipped without oil or petrol. The engine must

be lled with the correct grade of oil and petrol before starting the engine.

WARNING! Refuel in a well-ventilated area with the engine stopped. Do not smoke or allow ames

or sparks in the area where the engine is refueled or where petrol is stored. Avoid repeated or

prolonged contact with skin or breathing of vapor.

Clean the area around the petrol ller cap before removing the cap. Remove the warning tag,

check the fuel level.

Rell the tank if the fuel level is low.

Refuel carefully to avoid overlling or spilling fuel. There should be no fuel in the ller neck.

Clean up any overow or splashes of petrol before starting the engine.

Tighten the ller cap after lling.

Step 2 - Starting the Engine

2a Starting procedure quick guide

WARNING! Do not operate the machine in an enclosed or poorly ventilated areas as the exhaust

gas contains toxic substances. Keep hands, feet, hair and clothing away from all the moving

parts of the machine. The exhaust and other parts of the machine will become hot during use.

Make sure that the blade is securely fastened before starting the engine.

NOTE! To start the engine, make sure that the spark plug cap is located on the spark plug and

the machine is lled with sufcient oil and petrol.

Qualcast XSS41C User Manual

Questions and Answers: