EasyManua.ls Logo

Qualcast XSZ46D-SD - Safety Information; Maintenance and Storage; Preparing to Operate the Lawnmower; Step 1 - Filling with Engine Oil

Qualcast XSZ46D-SD
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
Important - Please read these instructions fully before operating or maintaining
6
Customer Helpline 01904 727500
www.gardenservicecentre.co.uk
WARNING!
- Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
- Never store the equipment with petrol in the tank inside a building where fumes can reach an
open ame or spark.
- Allow the engine to cool before storing in any enclosure.
- To reduce the re hazard, keep the engine, silencer, and petrol storage area free of grass,
leaves, or excessive grease.
- Check the grass bag frequently for wear or deterioration.
- Replace worn or damaged parts for safety.
- If the fuel tank has to be drained, this should be done outdoors.
Maintenance and Storage
Safety Information Preparing to Operate the Lawnmower
Step 1 - Filling with Engine Oil
IMPORTANT!
- The following procedures and adjustments must be performed before the engine is started. Do not
attempt to make any of these adjustments while the engine is running.
- Always use high quality detergent oil classied SAE30 oil (or equivalent eg 5W 30, often termed
as 4 Stroke lawn mower oil). Only use additives recommended by the engine manufacturer. To
prolong the life of your engine it is important that the oil is changed after the rst 5 hours of use.
Using non-detergent oil can shorten the engine’s service life and using 2-stroke oil will damage
the engine.
- To prevent engine damage the engine is shipped without oil or petrol. The engine must be lled
with the correct grade of oil and petrol before starting the engine.
- Running the engine with a low oil level will cause engine irreparable damage.
Check the engine oil level with the engine stopped and the mower on a level surface.
Remove the oil ller dipstick and wipe oil from it with a clean cloth.
Insert the dipstick into the oil ller neck, but do not screw it in.
Then remove the dipstick and check the oil level. The oil level must be between the Min and Max
marks on the dipstick. If near the lower level, ll to upper level with the recommended oil (SAE30 or
equivalent). Do not overll. Wipe away any spilt oil.
Add
Full
Intended Use:
This mower is designed for domestic lawn mowing only. Use in any other way is considered
contrary to the intended use. Compliance with the operation, service and repair as specied in this
handbook also constitute essential elements of the intended use.

Related product manuals