9
PROBLEM PROBABLE CAUSE SUGGESTED ACTION
Fails to split logs
The log pusher
moves jerkily,
making unfamiliar
noise or excessive
vibration.
Oil leaks around
cylinder ram or
from other points.
Log is improperly positioned.
The sizes or hardness of the log exceeds
the capacity of the machine
Reduce the log size before splitting it on
the log splitter.
Refer to “ Sharpening Wedge “ section to
sharpen the cutting edge.
Wedge cutting edge is blunt.
Locate leak(s) and contact the dealer.Oil leaks.
Contact the dealer.Unauthorized adjustment was made on
Max. Pressure Limiting Screw. Lower
max pressure rating was set.
Lack of hydraulic oil and excessive air
in the hydraulic system.
Air sealed in hydraulic system while
operating.
Loosen Bleed Screw by 3 ~ 4 rotations
before operating the log splitter.
Bleed Screw is not tightened before
moving the log splitter.
Tighten the Bleed Screw up before
moving the log splitter.
Oil Drain Bolt with Dipstick is not tight. Tighten the Oil Drain Bolt with Dipstick.
Hydraulic Control Valve Assembly and /
or seal(s) are worn.
Contact the dealer.
Check oil level for possible oil refilling.
Contact the dealer.
Refer to “Log Splitter Operation” section
for correct log loading.
TROUBLE SHOOTING / WARRANTY
WARRANTY
Your electric log splitter is guaranteed for one year. If the tool should stop working within one year from the date of purchase you
should return it to the retailer where you purchased it for a free replacement.
This guarantee is for do-it-yourself / home owner use only and is not valid if the tool is used for commercial or rental use.
The guarantee may not be honoured if in the opinion of Quality Craft, the tool has been misused, dropped, taken apart and or has
been the subject of unusual wear and tear, and/or if repairs have been made or attempted by those other than specified by Quality
Craft. Disassembling the tool will also void the warranty.
IMPORTANT. If you have any problems with your Quality Craft product please vist our website at www.qualitycraft.ca or call cus-
tomer service at 1-800-459-4409 before returning unit to the store. Save packaging until you are satisfied with your purchase.
Imported by
Quality Craft Ltd.
Laval, Quebec, Canada H7S 2G7
1-800-459-4409 (EST)
www.qualitycraft.com
Made in China
To Next Page
Loading...
Need help?
General