Once unpackaged, place the machine in the chosen place, for which a plug socket with an efficient grounding will be
required. Connect the network cable, place coffee in the hopper, open the closing sector and press the general
switch located under the grounds tray. The grinder will now be ready to operate.
To request the coffee dose, simply insert the filter holder until the end of the guide corresponding to the desired
dosage (right-hand guide for single dose and left-hand guide for double dose). When using the grinder for the first
time or whenever it has been completely emptied of coffee, press the dosage lever three times so the dispenser is
filled appropriately, and obtain the correct dosage.
accessories of the grinder, a
dummy control knob (fake)
is included, so that, whoever
wants, installs it in order to
avoid the modification of the
grinding point.
Installation and operation
Adjusting the grinding point
- To appreciate a significant change in the grinding point, you must at least fully turn the knob once.
- Never turn the knob to finer (clockwise) more than one full turn without grinding, given that this could
cause a blockage of ground coffee.
- Do not pour ground coffee into the coffee bean hopper.
- If the grinder is used continuously, allow to rest every
30 minutes to prevent it from overheating.
To Next Page
Loading...
Need help?
General
