11
QUANTEX GmbH 2014
The serial number of the device is read. This number is used by dealers request-
ing when buying the new brands.
Select the button Read to read the device serial number. The program will also
read and show the adapter type.
Beta-test
It’s used by beta-testers. Brands and units are discovered, which haven’t been
fully tested yet. Errors can occur in these units.
Device operation
Connection test
The test checks if the device connected or not and its quality. When one presses
the button, 2 types of tests are run.
• Ping-test checks if the device can be connected or not.
• Complete packages test sends the maximum length package and controls the
surge protector and Ethernet controller properties.
IP-address change
It can assign a device an IP- address.
An IP-address in a device or in a program is not necessary to be changed as a
rule. If there is a plant LAN, where IP-addresses have been already assigned, it’s
necessary to do it. Buttons for an IP-address change are shown by selecting the fol-
lowing keys: Ctrl+Alt+Y.
Beware! An expert is the only person to change the IP-address in the
device.
To Next Page
Loading...