Quantum DXi V1000 User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
98 Analyzer CLI Commands
Showing the Service
Ticket Analysis
syscli --show ticketanalysis --ticketnum <ticketnum>
This CLI command allows the admin user to show the service ticket analysis.
Showing the Service
Ticket Details
syscli --show ticketdetail --ticketnum <ticketnum>
This CLI command allows the user to show the service ticket details.
Closing All Service
Tickets
syscli --closeall ticket [--sure]
This CLI command allows the admin user to close all existing service tickets.
Analyzer CLI Commands
The following sections describe the supported Analyzer CLI commands:
• Analyzing the Network
• Enabling or Disabling the NetServer to Perform a Network Analysis
• Performing a Disk Analysis on the System
• Displaying the NetServer Status
• Displaying the Last Run Result of the Disk/Network Analysis
Analyzing the Network syscli --analyze network --ipaddress <ipaddress>
This CLI command allows the admin user to perform a network analysis of this
system with another system. NetServer should be enabled on the other system
specified in the ‘ipaddress’ options using the --set netserver command.
Enabling or Disabling
the NetServer to
Perform a Network
Analysis
syscli --set netserver --enable | --disable
This CLI command allows the admin user to enable or disable the NetServer on
the system to perform a network analysis.
Performing a Disk
Analysis on the System
syscli --analyze disk
This CLI command performs a disk analysis on the system.

Quantum DXi V1000 Specifications

General

Brand	Quantum
Model	DXi V1000
Category	Storage
Language	English