Quantum DXi V1000 User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Health Check CLI Commands 99
Displaying the
NetServer Status
syscli --getstatus netserver
This CLI command displays whether NetServer is enabled or disabled on the
system.
Displaying the Last Run
Result of the Disk/
Network Analysis
syscli --show throughput --disk | --network
This CLI command displays the last run result of the disk/network analysis.
Health Check CLI Commands
The following sections describe the supported Health Check CLI commands:
• Starting a Health Check
• Stopping a Health Check
• Scheduling a Health Check
• Listing the Health Check Status
• Editing the Health Check
• Getting the General Status of System Health Checks
• Getting the Health Check Schedule
Starting a Health Check syscli --start healthcheck
This CLI command allows the admin user to start a healthcheck on the system if
it is not running.
Stopping a Health
Check
syscli --stop healthcheck
This CLI command allows the admin user to stop a healthcheck on the system if
it is running.
Scheduling a Health
Check
syscli --sched healthcheck --never | { --time <time> [--day
sun|mon|tue|wed|thu|fri|sat]}
This CLI command allows the admin user to schedule a healthcheck on the
system.

Quantum DXi V1000 Specifications

General

Brand	Quantum
Model	DXi V1000
Category	Storage
Language	English