Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
CLI Error Codes 235
E6003274 Nodemanage:The node is already stopped.
E6003275 Nodemanage:The node is already started.
E6003276 Nodemanage:Failed to stop the node.
E6003277 Nodemanage:The node is not reachable through the
network.
E6003278 Nodemanage:The node is stopped.
E6003279 Nodemanage:The operation cannot be performed on the
local node.
E6003280 Nodemanage:The operation failed on one or more nodes.
E6003281 Nodemanage:Too many event handlers are already
registered.
E6003282 Nodemanage:Failed to parse the file.
E6003283 Nodemanage:Invalid cluster action.
E6003284 Nodemanage:Invalid cluster state.
E6003285 Nodemanage:Invalid cluster role.
E6003286 Nodemanage:Invalid power state.
E6003287 Nodemanage:The operation is not supported.
E6003288 Nodemanage:Core services failed, join not allowed.
E6003289 Nodemanage:This operation is currently disabled.
E6003290 Nodemanage:An error occurred while opening a file.
E6003291 Nodemanage:An error occurred while reading a file.
E6003292 Nodemanage:The operation failed due to a communication
error.
E6003293 Nodemanage:An error occurred while writing a file.
E6003294 Nodemanage:The node is not in a degraded state.
E6003295 Nodemanage:Invalid cluster severity.
E6003296 Nodemanage:The node is not present.
E6003297 Nodemanage:The reset operation failed.
E6003298 Nodemanage:The process monitor is already enabled.
E6003299 Nodemanage:The process monitor is already disabled.
E6003300 Nodemanage:Invalid process monitor state.
E6003301 Nodemanage:Invalid Hardware state.
Error Code Error Message
To Next Page