Quantum DXi V1000 - Page 288

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
280 CLI Error Codes
E8050081 CliListBonds: Failed to get /sys/class/net/bondX/bonding/
slaves file!
E8050082 CliListBonds: Failed to get /sys/class/net/bondX/bonding/
mode file!
E8050083 CliListBonds: Failed to get bond IP info!
E8050084 CliListBonds: Sysapi_GetBondOwner not implemeneted yet!
E8050085 Sysapi_GetPortState: Failed to get port state!
E8050086 Sysapi_GetCarrierState: Failed to get carrier state!
E8050100 The netcfg script is not found!
E8050101 The netcfg script failed to generate the xml file!
E8050110 Netmask cannot be zero!
E8050111 Netmask is invalid, the rightmost bit must be zero!
E8050112 Netmask cannot contain non consecutive zero bits
E8050120 Network device name cannot be empty!
E8050121 Network device name is missing before comma!
E8050122 Network device name is missing after comma!
E8050123 Device name must start with an alphabetic label (valid
format is <label><devno>[:<vifno>])
E8050130 Device name: device number is missing (valid format is
<label><devno>[:<vifno>])
E8050131 Device name: device number is invalid
E8050132 Device name: device number is out of range
E8050133 Device name: device number has invalid trailing character!
E8050137 MTU frame size is out of range! Range is 1500 to 9000 bytes.
E8050140 Device name: virtual interface number is missing (valid
format is <label><devno>[:<vifno>])
E8050141 Device name: virtual interface number is invalid
E8050142 Device name: virtual interface number is out of range!
E8050143 Device name: virtual interface number has invalid trailing
character!
E8050150 Command cannot run because custom configuration is
already in place!
E8050160 IP address cannot be empty!
E8050161 Max number of IP addresses exceeded!
Error Code Error Message