Quantum DXi V1000 - Page 289

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
CLI Error Codes 281
E8050401 EnableJumbo: Option "enable" is missing.
E8050402 EnableJumbo: Option "enable" requires a value
E8050403 EnableJumbo: Option "enable" has invalid value
E8050404 EnableJumbo: Failed to read/get option "enable".
E8050405 EnableJumbo: Failed to write/set option "enable".
E8050411 EnableJumbo: Option "bond0" is required because another
optional option is specified!
E8050412 EnableJumbo: Failed to read/get option "bond0".
E8050413 EnableJumbo: Failed to write/set option "bond0".
E8050421 EnableJumbo: Option "bond1" is required because another
optional option is specified!
E8050422 EnableJumbo: Failed to read/get option "bond1".
E8050423 EnableJumbo: Failed to write/set option "bond1".
E8050431 EnableJumbo: Option "dev" requires a value
E8050432 EnableJumbo: Option "dev" has invalid value
E8050433 EnableJumbo: Failed to read/get option "dev".
E8050434 EnableJumbo: Failed to write/set option "dev".
E8050435 EnableJumbo: Option "dev" is missing.
E8050441 EnableJumbo: Option "sid" is missing.
E8050442 EnableJumbo: Option "sid" requires a value
E8050443 EnableJumbo: Option "sid" has invalid value
E8050444 EnableJumbo: Failed to read/get option "sid".
E8050445 EnableJumbo: Failed to write/set option "sid".
E8050501 EnableJumbo failed!
E8050502 EnableJumbo: Device specified not found.
E8050503 EnableJumbo: Unable to create information needed to
enable jumbo frame.
E8050504 EnableJumbo: Jumbo frame already enabled.
E8050801 DisableJumbo: Option "disable" is missing.
E8050802 DisableJumbo: Option "disable" requires a value
E8050803 DisableJumbo: Option "disable" has invalid value
E8050804 DisableJumbo: Failed to read/get option "disable".
Error Code Error Message