Quantum DXi V1000 - Page 336

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
328 CLI Error Codes
E12050402 AnalyzeNetwork: Option "analyze" requires a value
E12050403 AnalyzeNetwork: Option "analyze" has invalid value
E12050404 AnalyzeNetwork: Failed to read/get option "analyze".
E12050405 AnalyzeNetwork: Failed to write/set option "analyze".
E12050411 AnalyzeNetwork: Option "ipaddress" is missing.
E12050412 AnalyzeNetwork: Option "ipaddress" requires a value
E12050413 AnalyzeNetwork: Option "ipaddress" has invalid value
E12050414 AnalyzeNetwork: Failed to read/get option "ipaddress".
E12050415 AnalyzeNetwork: Failed to write/set option "ipaddress".
E12050441 AnalyzeNetwork failed!
E12050442 AnalyzeNetwork: Unable to generate system analysis file.
E12050443 AnalyzeNetwork: System analysis file is already being
generated.
E12050801 SetNetserver: Option "set" is missing.
E12050802 SetNetserver: Option "set" requires a value
E12050803 SetNetserver: Option "set" has invalid value
E12050804 SetNetserver: Failed to read/get option "set".
E12050805 SetNetserver: Failed to write/set option "set".
E12050811 SetNetserver: Option "enable" is missing.
E12050812 SetNetserver: Failed to read/get option "enable".
E12050813 SetNetserver: Failed to write/set option "enable".
E12050821 SetNetserver: Option "disable" is missing.
E12050822 SetNetserver: Failed to read/get option "disable".
E12050823 SetNetserver: Failed to write/set option "disable".
E12050841 SetNetserver failed!
E12050842 SetNetserver: Netserver is already stopped.
E12050843 SetNetserver: Netserver is already running.
E12051201 AnalyzeDisk: Option "analyze" is missing.
E12051202 AnalyzeDisk: Option "analyze" requires a value
E12051203 AnalyzeDisk: Option "analyze" has invalid value
E12051204 AnalyzeDisk: Failed to read/get option "analyze".
E12051205 AnalyzeDisk: Failed to write/set option "analyze".
Error Code Error Message