Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Other System Configuration CLI Commands 61
Outgoing E-mail Server
CLI Commands
The following e-mail server CLI commands are supported:
• Displaying the Outgoing E-mail Server
• Setting the Outgoing E-mail Server
• Deleting the Outgoing E-mail Server
Displaying the Outgoing E-mail Server
syscli --get emailserver
This CLI command allows the user to display the outgoing e-mail server. An
example output of the outgoing e-mail server is shown below.
OutgoingE‐mailServer
HostnameorIPaddress=10.40.164.50
FromEmailaddress=DX75@quantum.com
Setting the Outgoing E-mail Server
syscli --set emailserver --hostname <server_name_or_IP> --emailaddr
<from_email_address>
This CLI command allows the admin user to add an outgoing e-mail server that
will be used to send the e-mail to configured recipients.
Deleting the Outgoing E-mail Server
syscli --del emailserver
This CLI command allows the admin user to delete an outgoing e-mail server.
Sending a Test E-mail syscli --send testemail --name <recipient_name>
This CLI command allows the admin user to send a test e-mail to verify the
e-mail configuration.
E-mail Home CLI
Commands
The following e-mail home commands are supported:
• Getting the E-mail Home Information
• Enabling or Disabling the E-mail Home Scheduler
• Adding an E-mail Home Schedule Recipient
• Deleting an E-mail Home Schedule Recipient
• Deleting All E-mail Home Receipts
• On Demand E-mail Home Status
• On Demand E-mail Home Configuration
To Next Page
Loading...
