Quantum DXi V1000 User Manual

Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
Other System Configuration CLI Commands 63
On Demand E-mail Home Status
syscli --send statusondemand [--emailaddr <recipient_email_address>]
This CLI command allows the admin user to send the e-mail containing Status
information, on demand.
On Demand E-mail Home Configuration
syscli --send configondemand --emailaddr <recipient_email_address>
This CLI command allows the admin user to send the e-mail containing Status
information, on demand.
SNMP Trap Destination
CLI Commands
The following SNMP trap destination CLI commands are available:
• Listing SNMP Trap Destinations
• Adding SNMP Trap Destinations
• Editing SNMP Trap Destinations
• Deleting SNMP Trap Destinations
• Deleting All SNMP Trap Destinations
• Listing the SNMP Community
• Adding an SNMP Community
• Editing an SNMP Community
• Deleting an SNMP Community
• Deleting All SNMP Communities
• Sending a Test Trap
Listing SNMP Trap Destinations
syscli --list snmptrapdest
This CLI command allows the user to list the configured SNMP trap destinations.
An example output of Trap Destination is shown below.
TotalTrapDestinations=2
TrapDestinationnumber=1
IPAddress=10.40.166.87
Name=public
SelectedTraps=
Failure,Warning,Informational,Available,Unavailable
TrapDestinationnumber=2
IPAddress=10.40.167.77
Name=public

Quantum DXi V1000 Specifications

General

Brand	Quantum
Model	DXi V1000
Category	Storage
Language	English